XG1v4-A - -Coax Out Port + Router

Thank you. What is the Coax "Out" port used for off of the cable box? I can't send the cable signal to my router via this coax port?

---

@XR360 wrote:

Thank you. What is the Coax "Out" port used for off of the cable box? I can't send the cable signal to my router via this coax port?

---

old analog TV output (CRT) that is SD only.

---

@XR360 wrote:

Here is some additional info and pictures. I appreciate any and all help. 

 

I currently have the livexfinityy Coax coming out of the wall into the "In" port on the splitter. 

 

From the splitter: 

 

Silver coax out into the cable box. 

Gold Coax Out into my wall port. (Seen in photo 2.) 

The wall coax port is a straight line into my office coax line. 

 

I am able to get aninternett connection when the wireless router is hooked up directly into the splitter off of the gold out coax. However, when run through the female wall port, there is nointernett signal in my office. 

 

I am able to push an "out" signal through afemall wall port or should I by pass this port and have a male coax going directly into where the gold out signal is? 

 

From the white wall port, into my office, is a brand newRG66 Quad line. 

---

swap the two splitter outputs. problem changes or remains the same? if same try separate cable run on floor to the other room. fixes issue? if so, then problem is somewhere between the splitter and the wall barrel to the other side of the wall to next barrel to the other device you called a wireless router but is probably the gateway (sometimes called a modem). 

I just ran the line behind the wall barrell connection. RG6 Quad directly to my office. Probably losing signal within the new wall port somewhere? Considered having a direct line out of the wall vs. having the barrell in port. 

Yes, prior to posting this I connected the modem directly to the out port on the splitter and received an Online signal just fine. Thinking I might be losing a signal somewhere into the port on the wall?

Thank you. 

Which cables are you referring to? Just curious. 

That should work if that coax goes from your wallplate to the other room and nowhere else. Check your coax connectors and make sure the center pin is protruding out far enough and there are no wire braids touching the center connector.