allen71cd's profile

Frequent Visitor

 • 

5 Messages

Wednesday, July 4th, 2018 7:00 AM

Closed

Manual code search on xr 15

So, I've finally found the code for my Onn TV using the A+D button, then entering 991, then CH up until my TV powers off. Now what?! How do I "set" that code so that the remote accepts it? I cannot find any information on what to do after the TV powers off. TIA

This conversation is no longer open for comments or replies and is no longer visible to community members.

Accepted Solution

Valued Contributor

 • 

178 Messages

7 years ago

After you do the A&D 991 code search press the center "OK" button to lock it in.

Gold Problem Solver

 • 

25.9K Messages

7 years ago

I believe it’s immediate

Gold Problem Solver

 • 

25.9K Messages

7 years ago

If you don’t do anything, it locks it on it’s own

Frequent Visitor

 • 

5 Messages

7 years ago

How long do I need to leave it and do I power the TV on with the remote or manually after letting it set?

Frequent Visitor

 • 

5 Messages

7 years ago

Sadly, it did not work.

Expert

 • 

24.6K Messages

7 years ago


@allen71cd wrote:
Sadly, it did not work.

do it again. when it works press the A and D button at same time. worked?

Frequent Visitor

 • 

5 Messages

7 years ago

I tried that before I posted and it didn't work either. Good idea though!

Frequent Visitor

 • 

5 Messages

7 years ago

Pressing the center OK button did it! Thank you so much!! I'm a little mad that I didn't think of that myself 😕

New Poster

 • 

1 Message

7 years ago

worked perfectly on my Brandsmart Atak TV

New Poster

 • 

5 Messages

7 years ago

Don't know if it is timing out or just running out of codes. I have a Sanyo PLV-Z4 projector. Have it programmed in my X5 remote. Is there a way to read the codes in the X5?

New Poster

 • 

1 Message

6 years ago

LG sk3d

New Poster

 • 

2 Messages

6 years ago

the process for the code search on the xr15 remotes you were doing are correct just missed the last power button to lock the code in place.

a+d till light goes from red to green

991 and ch + until tv turns off 

press power button to lock the code in place.

Regular Visitor

 • 

1 Message

6 years ago


@allen71cd wrote:
So, I've finally found the code for my Onn TV using the A+D button, then entering 991, then CH up until my TV powers off. Now what?! How do I "set" that code so that the remote accepts it? I cannot find any information on what to do after the TV powers off. TIA

 

forum icon

New to the Community?

Start Here