Comcast Labs Cable Signal Strength

In the Comcast Labs tab, I have the Cable Signal Strength option ON, to show as a bar graph. If it drops to LOW, a single red bar shows on the upper right when I go the guide. I refresh it, and most of the time, it resets to all green bars.

Why would the signal be read at different strengths, at different times on two different xg1-v4 boxes?

If the signal is low, why would it show on one box as low and the other box on good?

Responses

Accepted Solution

CCAndrew

Gold Problem Solver

•

25.9K Messages

5 years ago

The signal is the docsis signal to the internal modem. It goes to the first decimal point. So either box could be fluctuating just a little bit between pass and fail at different times, each box maybe reading a different frequency too (there’s more than 1), not a big deal until it’s consistently red

0

edInNJ

New Poster

•

1 Message

5 years ago

I've been consistently receiving the low signal level bar graph described above. Is there a diagnostic mode with which you can display the signal level? (the X1 box has the number 'XG1-A' for what it's worth).

0

X1

LeeSoFL

Comcast Labs Cable Signal Strength

CCAndrew

edInNJ

New to the Community?