michael112's profile

New Poster


1 Message

Fri, Mar 30, 2018 4:00 PM

pairing my tv with a xfinity remote

I am trying to pair my xfinity remote to my tv, but my tv manufacturer is not listed on the instructions  my tv is made by sylvania

This conversation is no longer open for comments or replies and is no longer visible to community members.


Accepted Solution


Silver Problem Solver


6.8K Messages

3 y ago



Program your remote using the RF pairing:

  1. Install the remote control batteries and make sure your TV and set-top box are powered on.
  2. Press and hold the "Setup" button until the LED at the top of the remote changes from red to green.
  3. Press the XFINITY button
  4. Enter the 3 digit code shown on your screen



Program your remote using a code:

  1. Turn on the TV you are programming.
  2. Press and hold the "Setup" button until the status LED at the top of the remote changes from red to green.
  3. Type in the 4-digit or 5-digit code listed below using the number buttons. Additional codes may be found in the remote manual.

    Most likely code: 10171 (Sylvania code)

    Others to try: 10054, 11864, 11963, 11886, 11913, 12248, 11665, 11271, 10096, 10187, 10020, 10065, 10028, 11314, 10030, 10024, 14053, 13332, 10587, 10186, 10036, 12597, 12275, 11454, 12253 (Sylvania codes)

  4. If the code is entered correctly, the status LED will flash green twice. If the status LED blinks red, then green the code was not entered correctly. Check that you are entering the correct code and try again.
  5. Use the remote to operate your TV (use Power, VOL, etc.)
  6. If these steps don't work, try another 4-digit or 5-digit code and repeat the above.

I found these Sylvania codes at Comcast's remote setup site: https://www.xfinity.com/support/remotes/



Aim Anywhere Pairing:

1. Press and hold the Setup button for 3 seconds, until the status LED changes from red to green.

2. Press the XFINITY button on the remote. Your TV should display on-screen instructions to enter a 3-digit code. If the instructions do not appear, press the XFINITY button again - up to 2 more times.

3. Follow the on-screen instructions to enter the 3-digit code that appears.

4. Once the code is correctly entered, your XFINITY Remote is paired with the device.



For more information about programming your remote see here: https://forums.xfinity.com/t5/TV/ANSWERED-How-to-Program-Your-Xfinity-X1-Remote-for-TV-and/ta-p/2942606





Bronze Problem Solver


2.1K Messages

3 y ago

What exact model Sylvania TV is it?

New to the Community?

Start Here