Frequent Visitor
•
5 Messages
Anthem MRX 500 Remote Code
I have an Anthem MRX 500 A/V box and would like to set it up on the X15 Remote. Does anyone know what code I might use? If I could just get On/Off, Volume and Mute I would be happy.
Frequent Visitor
•
5 Messages
I have an Anthem MRX 500 A/V box and would like to set it up on the X15 Remote. Does anyone know what code I might use? If I could just get On/Off, Volume and Mute I would be happy.
Accepted Solution
CCAndrew
Gold Problem Solver
•
25.9K Messages
5 years ago
0
0
bfemmel
Frequent Visitor
•
5 Messages
5 years ago
No, Anthem is not on the list. That would have been too simple. 😆
I went to the Anthem webist, (https://www.anthemav.com/), and looked to see if they were a division of someone else whose code I might use or if they had a different brand name to look under but didn't find one. I also searched all the support documentation to see if they had a list of the codes for the X1 DVR systems but they did not or I couldn't find it. I'm sort of at a loss here.
Using two remotes is not the end of the world but I would like to find out if the codes for another system are at least partially compatible so I could at least get the basic functions to work. I am going to send e-mail to Anthem to see if they know as I did not see any information related to Xfinity on their site.
One other question I have is that I see on the Xfinity site that there is a way to scan through a number of codes to see if anything works. However all the instructions start with "Press the Setup Button which the XR15 does not have so I am still wandering in the wilderness.
0
0
CCAndrew
Gold Problem Solver
•
25.9K Messages
5 years ago
0
0
bfemmel
Frequent Visitor
•
5 Messages
5 years ago
Thanks for the suggestion but that does not work.
On the XR15 remote, pressing A gets me to Setup. Pressing A+D does nothing. Pressing D alone does nothing. And even when I get to setup I still don't have a way of searching for the correct code except by going through the pre-loaded list of manufacturers and Anthem is not one of them so I am still at the same spot. I need a way to scan through the codes to see if one of them will operate the Audio.
0
0
bfemmel
Frequent Visitor
•
5 Messages
5 years ago
Thanks, I guess that solution worked at least as far as getting into that mode. However, I was not lucky enough to have my system, come up. I hit CH UP for 100 codes and nothing. So, I guess I just use two controllers. Thanks for the help.
0
0
captainmike1
Contributor
•
14 Messages
5 years ago
I have been trying for almost a year to get the remote to work with an anthem receiver. Comcast has not helped and anthem suggested a logitech remote which I have used in the past but it is far short of the Xfinity remotes.
I am not sure why Comcast wont add the codes, they are a billion dollar company.
0
0
bfemmel
Frequent Visitor
•
5 Messages
5 years ago
For me it was not worth it. Xfinity may th ink that it is a reason to get a new receiver but I look at it as a reason to go back to the Tivo and dump the Xfinity system. Unless there is something basic in the hardware there is no reason they would not do it except that it does not pay. If there are only a few of us with Anthem why would they waste the time?
0
0