Reboot dvr. Pull plug, hold down power button a few seconds to drain capacitors/clear ram.
Unpair the X11 remote: Press the Setup button on the remote until the LED at the top of the remote changes from red to green.
The LED at the top of the remote will blink green twice to indicate that the remote has been reset.
Re-pair remote: hold down set-up till green, touch Infinity key. Enter code generated. Yes to program tv.
Also set the remote to control your avr if necessary. Just go along with the steps.
Then press Exit 3 times then 0030. Should reprogram remote to 30 second skip.
... View more