Community Forum
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for
About xedious
since
01-29-2014
09-23-2019
xedious
Contributor
26
Posts
1
Kudos
1
Solution
08-21-2019
02:55 PM
Just thought I'd put this out there to save you the pain I went through with the <Edited> tech support person.
I just got the new box and the first thing it asks is to select language. Hit the button on the remote and nothing. It wasn't paired.
I have the xr15 remote that doesn't have a setup button. You need to do this:
Hold down A. While holding down A, hold down D. The light will change to solid green I believe. Enter 981 and it should work after that.
Tech support had me pairing to my TV, entering bogus codes, changing batteries, and finally suggesting that they send another remote! They were WAY too chatty as well. Just help me with the issue. I don't care what you had for lunch.
... View more
02-28-2019
06:21 PM
1 Kudo
It would be nice to turn the warnings off. I was getting them even after I turned port forwarding off. Isn't it near impossible to hack xbox anyway?
... View more
02-25-2019
10:19 PM
Just got upgraded to something at comcast and now I've gotten 80 something attacks on my Xbox one. Probably nothing but it is very annoying.
... View more
05-28-2016
11:48 PM
Yes, everything is working now.
I don't have the X1 DVR yet. I still have the older one. I have no idea how upgrading to the X1 dvr will mess things up since my DVR is in the room I'm using the actiontec's for.
I have the bigger X1 box and a smaller one (I call it the slave because it depends? on the larger one being on the same branch of coax) downstairs.
Sorry if I'm using the incorrect terminology. And thanks to you both for the suggestions and education.
... View more
05-28-2016
11:39 PM
I was forced to get X1 installed a couple of months back because two of my set top boxes suddenly stopped working. You may not have seen my post where I unplugged the X1 boxes and moca came back. Does X1 send some interrupt signal or something? My next thing to try was setting the moca adaptors to a different frequency.
... View more
05-28-2016
11:18 PM
Thanks for the quick reply! I think I may have it figured out. I unplugged the X1 master and slave boxes downstairs. I then rebooted the actiontec's and they connected immediately. If X1 is the problem at least I know what to do now if I ever have to reboot the moca.
... View more
05-28-2016
08:41 PM
My wireless will not reach into my upstairs room. I've tried every kind of wireless extender with no luck.
I bought two Actiontec ECB2500C MoCA Network Adapters. I also installed a POE filter outside on the cable coming in. Now it is like a wired network through my coax! Great speed!
However, if the power goes off or I happen to unplug one, they have trouble connecting. The 'coax' lights will not come on.
The last time this happened they just 'magically' started working again. I have tested them with a short length of coax and they are not defective.
I can only guess that the signal isn't strong or clean enough for them to get a 'lock'?
As I write this, they are not connecting and I am out of ideas. I accidentally unplugged one. They have been connected and working for months.
My house is basically split up cable-wise. I have a dedicated coax for the cablemodem. I have an upstairs section (where I have moca installed) and the downstairs section has the new X1 boxes.
Can a technician come out and troubleshoot the signal? Or am I out of luck?
... View more
Latest Tags
No tags yet
