About sbudaj

sbudaj · ‎01-09-2021

Tried everything. Too hard to rewire. I tried using the Xfinity Stream App beta on my Samsung TV. Works fairly well. Not as good as the box. I'll send the box back until some day that I rewire that outlet.

sbudaj · ‎01-02-2021

I have an X1 4K DVR and 3 remote TV boxes. One of the remote boxes stopped being able to receive a signal. I have called in and they have replaced the box twice. All boxes are hardwired to coax cable. The one that stopped working boots up and after the Welcome screen, it says to check the cables to make sure they are tight, etc. Of course all the cables are tight. I suspect something may have happened to the cable going to that box. I would like to switch to a wireless box rather than having to rewire that location. However, I am using my own router and the cable modem is in Bridge Mode. Will I be able to use a wireless box such as the Xi6 in that location with my own router? If not, any other suggestions? Thanks.

sbudaj · ‎09-29-2019

Sorry I don't have an answer to your question, but I have a related issue. I have a similar setup but all of my remotely controlled extended devices that used to work fine have stopped working. I see the flash of the remote on the receiver end as well as the transmitter end of the extenders, but none of my devices are responding. (they all respond to their remote when pointed directly at the device.) Maybe someone has an answer that will help both of us.

sbudaj · ‎11-05-2015

One other thing that seemed to have changed recently: when you use the quick guide on the right side of the screen and you select a new channel, the bottom scroll bar appears on the screen and you can't do anything unless you hit the exit or last button. I used to be able to immediately hit the right control button to go back to the quick guide on the right side of the screen to find another channel. But, now you have to either wait for the bar to go away on its own or hit yet another key to make it go away before you can go back to the quick guide.

sbudaj · ‎09-12-2015

Set DVR to record a football game today and set it to auto extend. Game went over by about 15 minutes, but it did not record the extra time. Stopped at exactly 3 hours. Is this unreliable? Should I just set it to record extra time in the future manually? Thanks.

sbudaj · ‎09-07-2015

Clearly, not everyone is having problems. Maybe I'm one of the lucky ones, but after installation about a month ago (upgrading my regular comcast anyroom dvr system several years old), my X1 system has worked flawlessly. I have had a few friends switch over to X1 in the last couple of weeks and they report similar service as I am experiencing.

sbudaj · ‎08-02-2015

Is this the correct answer? My pause also stopped working on the companion boxes. Thanks.

About sbudaj

Re: X1 not working in a specific room

X1 not working in a specific room

Re: Pace Xfinity box and IR extender

Re: Upcoming X1 Updates

Re: Upcoming X1 Updates

Re: Upcoming X1 Updates

Re: Upcoming X1 Updates