Upload speeds have been 0.2Mbps which is basically unusable to send anything. Download speeds are good (over 50Mbps). I checked the connection levels on the cable modem (SBG6580) and it shows this (one upstream channel is at 50.5 to 51.5dBmV, others at 46 to 47dBmV). I checked the cables to make sure they are tight, one splitter outside at the side of the house but no splitters inside. Any ideas before I call for a tech? Thanks in advance.
The upstream power is too high and it may be intermittently fluctuating even higher to out of spec levels. That can cause random disconnects, spontaneous re-booting of the modem, speed, packet loss, and latency problems.
In a self troubleshooting effort to try to obtain better connectivity / more wiggle room, check to see if there are there any excess/unneeded coax cable splitters in the line leading to the modem that can be eliminated/re-configured. Any splitters that remain should be high quality and cable rated for 5-1002 MHz, bi-directional, and no gold colored garbage types like GE, RadioShack, RCA, Philips, Leviton, Magnavox, and Rocketfish from big box stores like Home Depot, Lowes, Target, Wal-Mart etc. Splitters should be swapped with known to be good / new ones to test.
If there aren't any unneeded splitters that can be eliminated and if your coax wiring setup can't be reconfigured so that there is a single two way splitter connected directly off of the drop from the street/pole with one port feeding the modem and the other port feeding the rest of the house/equipment with additional splits as needed, and you've checked all the wiring and fittings for integrity and tightness and refresh them by taking them apart then check for and clean off any corrosion / oxidation on the center wire and put them back together again, then perhaps it's best to book a tech visit to investigate and correct.