Regular Visitor
•
1 Message
New Modem fails to activate. netgear CAX80
I have decided to upgrade my internet. I purchased a netgear CAX80 modem (on xfinity approved list) to replace my current modem and router. Currently have a netgear cm500 modem and a netgear R8000 router. Internet service is fine under current configuration. I Followed the instructions for new modem installation. When using the recommended Nighthawk app, upon trying to activate my modem with xfinity I receive a message saying something has gone wrong contact xfinity. This occurs just after verifying my xfinity account credentials. I also tried using my pc to activate modem with same results. I called xfinity customer support. They went through their script to try and resolve the issue but were not able to. They have scheduled a tech to come and see if something is wrong on my end, but i currently have service with my old modem/router.
Is there something I have missed or overlooked. Any ideas will be greatly appreciated. Thank you.
carson_adkins
Regular Visitor
•
2 Messages
5 years ago
0
0
pluto459
New Poster
•
1 Message
5 years ago
Did you get this figured out? THer eis guy on the amazon page saying had same issue and xfinty said call netgear and was solved. I asked him what the solution was and no reply yet. Another said they had to do something street side. My guess is the 3.1 software conflicts unless they send that signal. Trying to upgrade speed and not really wanting all these headaches.
0
0
carson_adkins
Regular Visitor
•
2 Messages
5 years ago
0
0
jdimailig
New Poster
•
1 Message
5 years ago
0
0
zheka2
New Poster
•
1 Message
5 years ago
Same issue. CAX80 goes into infinite reboot/reset cycle and can't even hold a wifi connection.
0
0