Community Forum

Downstream and upstream channel review

Highlighted
New Poster

Downstream and upstream channel review

The modem is CM1200. Channel 32 is never able to be locked. Also, what are the power level or SN level supposed to be? In some of the forum threads, it seems like my upstream power is high(?). 

 

downstream.JPGupstream.JPG

Thanks

Highlighted
Expert

Re: Downstream and upstream channel review

Can't see your pics. Since you are a new poster, they need to be approved by a Forum Admin. That could take some time. In the interim, you could try hosting them at one of those free third-party pic hosting sites like Imgur or Photobucket and post the link to them here.



I am not a Comcast Employee.
I am a Customer Expert volunteering my time to help other customers here in the Forums.
We ask that you post publicly so people with similar questions may benefit from the conversation.
Was your question answered? Mark the post as Best Answer!
Highlighted
New Poster

Re: Downstream and upstream channel review

Highlighted
Expert

Re: Downstream and upstream channel review

The upstream power is too high and it may be intermittently fluctuating even higher to out of spec levels. That can cause random disconnects, spontaneous re-booting of the modem, speed, packet loss, and latency problems.

In a self troubleshooting effort to try to obtain better connectivity / more wiggle room, check to see if there are there any excess/unneeded coax cable splitters in the line leading to the modem that can be eliminated/re-configured. Any splitters that remain should be high quality and cable rated for 5-1002 MHz, bi-directional, and no gold colored garbage types like GE, RadioShack, RCA, Philips, Leviton, Magnavox, and Rocketfish from big box stores like Home Depot, Lowes, Target, Wal-Mart etc. Splitters should be swapped with known to be good / new ones to test

If there aren't any unneeded splitters that can be eliminated and if your coax wiring setup can't be reconfigured so that there is a single two way splitter connected directly off of the drop from the street/pole with one port feeding the modem and the other port feeding the rest of the house/equipment with additional splits as needed, and you've checked all the wiring and fittings for integrity and tightness and refresh them by taking them apart then check for and clean off any corrosion / oxidation on the center wire and put them back together again, then perhaps it's best to book a tech visit to investigate and correct.



I am not a Comcast Employee.
I am a Customer Expert volunteering my time to help other customers here in the Forums.
We ask that you post publicly so people with similar questions may benefit from the conversation.
Was your question answered? Mark the post as Best Answer!
Highlighted
New Poster

Re: Downstream and upstream channel review

There is no splitter from wall outlet to the modem. The only splitter is outside the house from the street pole to the house. Thanks.

Highlighted
Expert

Re: Downstream and upstream channel review

Then as stated, you'll need a tech visit to investigate and correct the problem. 

 

Bear in mind that if the premises facing techs can not find or fix a problem at your home, it is they who are responsible for escalating it to their line / network / maintenance dept. techs. The problem may lie beyond your home in the local neighborhood infrastructure somewhere but it is their S.O.P. to start at the home.

Good luck with it !



I am not a Comcast Employee.
I am a Customer Expert volunteering my time to help other customers here in the Forums.
We ask that you post publicly so people with similar questions may benefit from the conversation.
Was your question answered? Mark the post as Best Answer!
Highlighted
New Poster

Re: Downstream and upstream channel review

thanks.