Community Forum

How to forward port with xfi, using different start and end port numbers

Highlighted
New Poster

How to forward port with xfi, using different start and end port numbers

Hi,

 

title says it all: following the xfi procedure to forward a port from my gateway to a connected device, I can't seem to be able to specify a different start port (on the gateway) and end port (on the device). I can only specify one port number used for both start and end.

What I want to achieve is to forward say:

- port 2022 on the gateway to the port 22 of a given device

- port 2023 on the gateway to the port 22 of another device

this way I can ssh into one device or the other, by chosing the proper port.

Can I achieve that with xfi ? and if yes how ?

This was possible with the old admin interface (10.0.0.1)

 

Thanks in advance.

New Poster

Re: How to forward port with xfi, using different start and end port numbers

they don't answer because its not possible with the new interface... it's completely rediculous. I ended up haveing to put the router in bridge mode, set up a different router and access point. Good Luck!