We have our own modem with voice (Netgear CM1150V). Recently activated our xfinity voice service, it is (finally) working. I say finally because there were glitches porting our number over. All is working now. When I plug a phone directly into the modem, that phone works. When I plug the modem directly into the wall jack to give all the phone jacks in the house dial tone- nothing. I've disconnected the old land line wires at the box on the outside of the house. I know all my internal phone wiring works (because it did the last day we had a land line). I'm at a loss of why this isn't working. I've asked on the Netgear website, no help there. So thought I'd try here as other likely have the same modem. Thanks in advance!
@stephenie89 wrote: ... When I plug a phone directly into the modem, that phone works. When I plug the modem directly into the wall jack to give all the phone jacks in the house dial tone- nothing. ...
Do you have a phone cord connecting the CM1150V to a wall jack to energize the other jacks? If that doesn't work, as stated, you have a wiring problem somewhere.
@stephenie89 wrote: Yes, yes,and yes. ...
It isn't realistic to expect Forum members to troubleshoot a wiring issue in your home. Comcast can't do it remotely either. You need someone on site with appropriate test equipment. Sorry to disappoint!
Do you happen to have a 3rd party alarm system connected to your phone wiring?
I have this same problem....but I get a busy signal on all the other jacks in the house. The phone that is plugged directly into the Gateway works fine.
When I use a splitter directly on the Gateway, i get the same behavior....dial tone on one phone and busy signal on the other....so I suspect its a Gateway problem and not a house network problem.
I had this set-up and problem. Use one xfinity voice line. Out of the back of the modem, I had one phone line splitter. One side of the splitter went directly to an office phone, the other side of the splitter went into a wall phone jack to energize other jacks around the house. Everything worked fine, until one day it didn't.
Turns out that I had a short in my home wiring. Some of the phone wires in the interface box weren't properly terminated, and must have moved enough (from wind, leaf blower nearby, who knows?) that they were creating a short.
Comcast tech terminated the wires in the box, now everything works properly. Although still have an ever present hum in the line on both phones.
So, nothing had changed that I could figure out. One day it worked, and then another day it didn't.
One thing I did that seemed to help is that the Phone Cable I was using had only two conductors in it. I switched to a four conductor cable and things seemed to have improved. Also, the wall jack in the room had two plugs....I think one was wired for "Line 1" and the other for "Line 2". This was causing problems for my alarm system not able to call out properly. When I switched ports, things seeme to work fine now.