G503's profile
Expressive Exchange
Conversation Starter
1st Best Answer

Frequent Visitor


18 Messages

Sun, Nov 15, 2020 5:00 PM

XB7 Gateway > Connection > WAN Network DOCSIS /Ethernet/Auto

On the XB7 under Gateway > Connection > WAN Network there is a dropdown for DOCSIS /Ethernet/Auto.

When you change it to Ethernet then under Gateway > Hardware > LAN Ethernet, Port 4 shows as WAN Ethernet.

Set to Auto could this be a dual wan failover setup? Primary from the Comcast, secondary from another WAN source plugged in to Port 4 ?


On page 14 of the user manual;
"The lower right port supports 2.5 Gbps and may be configured as an Ethernet WAN port when connected to a
fiber ONT."




No Responses!

New to the Community?

Start Here