Visitor
•
3 Messages
Enabling bridge mode
Hello, I recently got a new XFi gateway for 1 gig internet. I am trying to connect my existing router to it. I followed the steps to enable bridge mode that is available in the help articles. However, when i open the admin portal, there is no button next to Bridge mode
its just empty like below. the browser says there is an error in the javascript
Bridge Mode:
user_mo59br
Visitor
•
5 Messages
2 days ago
Hi, we've got another thread going on here with the same issue (https://forums.xfinity.com/conversations/customer-service/unable-to-turn-on-bridge-mode/6980c49cbef17951d8a6b119?commentId=6982aeca18df686529af935a)
I'm not an expert, but it looks like the button/switch is referenced in the html, it's just not showing up for some reason. It looks like people with multiple models are having this trouble so I don't know why xfinity hasn't fixed this yet.
2
ChillyBillz
Visitor
•
1 Message
10 hours ago
I had this same issue yesterday. Could not put my Xfinity CGM4981 into Bridge Mode even with the tech on the phone. I had to hold the reset button down on the back of the modem (while plugged in) until the light on the front turned green. That factory reset it. After it fully rebooted I went back into the admin page and I had the ability to turn on bridge mode.
Just an FYI - the Technicolor CGM4981 Gateway is hot garbage, and I mean HOT. It is known to overheat and have thermal issues, once it gets too hot for too long it's basically no good, replace it at that point.
I have a tech coming out today to check our lines (getting 2500 upload latency and 700 download latency) contstanly, even when a device is LITERALLY sitting on my router.
0
0