kzooblue's profile

New Poster

 • 

1 Message

Saturday, December 12th, 2020 3:00 PM

Closed

Constant T3 timeouts

Hello!

 

I've been having issues with latency spikes lately (especially noticeable during gaming with 300-500ms and above) and was curious if any of the below info helps narrow down an issue. There are a bunch of T3 (no T4) time outs.

 

Signal:

 

https://imgur.com/a/3nKgrrZ

 

Logs:

 

https://imgur.com/a/YKzLOtI

 

Please let me know!

 

Thanks!

This conversation is no longer open for comments or replies and is no longer visible to community members.

Expert

 • 

111.5K Messages

5 years ago

The upstream power is on the high side and it may be intermittently fluctuating even higher to out of spec levels. That can cause random disconnects, spontaneous re-booting of the modem, speed, packet loss, latency problems, and the un-bonding of channels.

In a self troubleshooting effort to try to obtain better connectivity / more wiggle room, check to see if there are there any excess/unneeded coax cable splitters in the line leading to the modem that can be eliminated/re-configured. Any splitters that remain should be high quality and cable rated for 5-1002 MHz, bi-directional, and no gold colored garbage types like GE, RadioShack, RCA, Philips, Leviton, Magnavox, and Rocketfish from big box stores like Home Depot, Lowes, Target, Wal-Mart etc. Splitters should be swapped with known to be good / new ones to test

If there aren't any unneeded splitters that can be eliminated and if your coax wiring setup can't be reconfigured so that there is a single two way splitter connected directly off of the drop from the street/pole with one port feeding the modem and the other port feeding the rest of the house/equipment with additional splits as needed, and you've checked all the wiring and fittings for integrity and tightness and refresh them by taking them apart then check for and clean off any corrosion / oxidation on the center wire and put them back together again, then perhaps it's best to book a tech visit to investigate and correct.

forum icon

New to the Community?

Start Here