Visitor

 • 

1 Message

11/20/2026 1:47 AM

Bridge mode or alternative for fiber connection

Xfinity just installed fiber into my neighborhood (first fiber option here) and I immediately subscribed, confirming with the agent that I’d be able to use my own equipment. This was confirmed by the installer, who said I could plug my router directly into the ONT, as I’d expect.  This is also claimed on the website. As all who have this service apparently know by now, this is not true. I have no idea what weirdness Xfinity is passing - some DOCSIS oddity? - but apparently a Xfinity device is needed to convert it to normal IP over Ethernet.  Not happy, but I was told I could put the device (an XER10) into bridge mode.  However, there did not seem to be any setting for this.  Contacted support, who - after a lot of research while on the phone with me - determined they could set it.  Fine, do so ok, done.  I quickly discovered the device was not in bridge mode. Called back, got another CS rep who needed to do similar research, determined they could set it, did so, and told me the device indicated to them it was in bridge mode.  Obviously it wasn’t, which the rep could also see. Over the course of an hour call, the rep found out what Xfinity claimed about this, also determined that none of it was true, but could offer no help.  Searching the fora, I see that this is a known situation that has been upsetting customers for a long time, with no resolution offered by Xfinity. But the newest complaints I saw were a while ago.

So - has anyone since found a solution or viable workaround?  I’d be happiest with plugging directly into the ONT. I’d settle for bridge mode with some Xfinity device (doesn’t have to be the XER10, but I have no interest in paying for it).  The third option - dumping the Xfinity service I just got - is undesirable because my ISP alternative is the 45Mb VDSL service I came from.

Oldest First
Selected Oldest First
No Responses!
forum icon

New to the Community?

Start Here