Using On-screen configuration for Flex X15 remote

Flex does not offer channel control support.  You can use the XR15 remote to navigate through the interface and control your tv power and volume control.  

Although that sounds really bad to put out a remote with a channel change button to not change channels.  However, the issue is the on-screen process is NOT working.  Not being able to select the brand of the TV pretty much makes the process broken.

Samsung should be the first brand listed when the brand selection page loads.   You shouldn't have to type it in.    These codes are available on Samsung's support site.   

1. Press and hold the xfinity and Mute buttons together for five seconds until the light at the top changes from red to green.
2. Type the first five-digit code for the TV manufacturer.
   • If the remote light blinks green twice, the code is correct.
   • If the remote light blinks red then green, the code is incorrect.
3. Aim the remote at the TV, and press the Power button.
   • If the TV turns off, turn the TV back on and make sure the Volume and Mute buttons work.
   • If the TV doesn't turn off, try the next code.

Thank you for the list of Samsung codes.  This however does not address the problem with the on-screen process not working.  Is there anyone at Comcast intersted in addressing that issue?

Thank you, this response makes more sense given the original message.  Ignoring the problem does not make it go away.