I just subscribed to Comcast earlier this week with the 400 plan. I moved here last week, and k ow that there was Comcast here earlier before I moved. So no professional install should be required. I also know that my modem, SB6183, doesn't support that 400 plan (at most does 250), but I do plan on upgrading the modem in about a month. Was hoping I could pay for 400, and just get 250 for a month.
I've called tech support 3 times, and gotten 3 different answers.
First time, they said they couldn't do anything, and would just leave it as is.
Second time, said that the speed and bill is linked. I can't pay for 400 and get 250. So he downgraded me to 250, but did mention I had the wrong boot file (which he gave me the supposedly correct one). Still same slow speed.
Third time I called, was told I have the incorrect/older firmware on my modem, and also that I have the 50 plan, and not the 250 plan. Just checked, and I have D30CM-OSPREY-18.104.22.168-GA-01-NOSH firmware, for what it's worth. He tried to push the updated firmware, which took a 15 or so minutes, but ultimately failed due to slow speed and timeouts. Was advised to call the manufacturer, Arris, to see if they update it...and they told me it was the ISP's responsibility, and that end customers can't do it.
I've uploaded my modem's status page, but not sure what to do at this point. Call tech support for a 4th time and get a 4th different answer? Just trying to get decent internet speed before I upgrade my modem. And I also don't want to upgrade my modem (roughly $200) and run into the exact same issue on the off chance it's not my modem's fault.
You have some power level and SNR problems going on there. This should be addressed first before anything else.
In a self troubleshooting effort to try to obtain better connectivity / more wiggle room, check to see if there are there any excess/unneeded coax cable splitters in the line leading to the modem that can be eliminated/re-configured. Any splitters that remain should be high quality and cable rated for 5-1002 MHz, bi-directional, and no gold colored garbage types like GE, RadioShack, RCA, Philips, Leviton, Magnavox, and Rocketfish from big box stores like Home Depot, Lowes, Target, Wal-Mart etc. Splitters should be swapped with known to be good / new ones to test
If there aren't any unneeded splitters that can be eliminated and if your coax wiring setup can't be reconfigured so that there is a single two way splitter connected directly off of the drop from the street/pole with one port feeding the modem and the other port feeding the rest of the house/equipment with additional splits as needed, and you've checked all the wiring and fittings for integrity and tightness and refresh them by taking them apart then check for and clean off any corrosion / oxidation on the center wire and put them back together again, then perhaps it's best to book a tech visit to investigate and correct.
The version of firmware that you have is identical to mine and is the current one.
If the tech finds that the problem is on their (Comcast's) side of the grounding block / demarc point, you won't be charged. Good luck !
I'm getting 120 on a 400 plan with an Arris SB8200 modem. That might seem bad, but it's better than 25 on the same 400 plan, which is what I used to get a week ago. Old post here for reference: https://forums.xfinity.com/t5/Your-Home-Network/SB8200-Internet-is-around-15-100-Mbps-on-400-plan/m-...
Comcast tech came out to check my wiring. Apparently there was a bad cable from the box on the street to the house. There was already a newer and thicker cable ran, just the ends weren't spliced or connected. Guessing old tenant wasn't home when it was ran, then the old tenant just didn't want to deal with it. In addition to finishing up that, tech replaced the inside connectors to include where it's coming out of the wall, and we confirmed there are no splitters. Can't get much better than that, we think. He checked the signal at the street and at my house, and it's getting a 37 signal.
Modem reports 37 - 39 on the various channels, which I'll attach a screenshot of. Still only 120 down. Also, my downstream light on the physical modem does light up solid blue (meaning "*Blue - Indicates DOCSIS 3.1 operation (high-speed Internet access) which may not be available in all locations. Check with your service provider for availability in your area."), but my upstream light is green, (meaning "Green: upstream channel is connected in DOCSIS 3.0 mode"). A different tech said they should both be blue. A tech/dispatch on the phone has verified I have the correct boot file for 400 (D31CM-PEREGRINE-22.214.171.124-GA-04-NOSH) and the modem is activated, which both have been true for 3ish months.
The only thing we can think to do is move the modem to where it comes into the house to see the speed there, to eliminate the house wiring as an issue. I'll probably do that later today. Failing that, he recommends switching to a Comcast modem/router combo which he sat in a meeting that said their modem is better for X reason than off the shelf modems. Something about off the shelf pushes 4 something of power, while theirs does 6. I can maybe see that for run of the mill modems being not so good, but not for an SB8200, personally. The only other potential issue I see is the 780000000 frequency has lot Corrected, with modulation listed as Other, but the tech says Comcast doesn't even use that one, so it's not an issue.
Are we missing anything simple? Or maybe not so simple, just missing anything at all?
Can't see your pics. Since you are a new poster, they likely need to be approved by a Forum Admin. Or you may need to make a minimum number of posts.
You could try hosting them at one of those free third-party pic hosting sites and post the link to them here.
You won't get a blue upstream light as Comcast does not yet offer DOCSIS 3.1 for the upstream.
Hopefully this works better: https://imgur.com/a/l2PzQpj
Very...misleading...that I can see them (but can't when logged off). Maybe the forum admin should implement something that states people can't see my pics till approved (or hit a certain post count), so new users don't think everything is good to go when it's not.
FWIW, the stats do look good now.