Community Forum

Open ports on LAN-side of Arris T1682G

New Poster

Open ports on LAN-side of Arris T1682G

A LAN-side scan of my Arris T1682G shows ten open or filtered ports.  Should there be this many?  Anyone have insight into what the ports > 443 are?  Nmap results below.


nmap -p-

Starting Nmap 7.70 ( ) at 2018-05-14 16:33 PDT

Nmap scan report for

Host is up (0.0020s latency).

Not shown: 65525 closed ports


22/tcp    filtered ssh

23/tcp    filtered telnet

53/tcp    open     domain

80/tcp    open     http

443/tcp   open     https

2601/tcp  open     zebra

7547/tcp  filtered cwmp

49152/tcp open     unknown

51515/tcp open     unknown

58081/tcp open     unknown

New Poster

Re: Open ports on LAN-side of Arris T1682G

Look like port forwarding setup for a game console or some other device that requires specific ports to be open.


Re: Open ports on LAN-side of Arris T1682G

Zebra (TCP 2601) is an older networking protocol that tells devices where to go on yout network. TCP 7547 is the CWMP (CPE WAN Management Protocol) , which is an autoconfiguration protocol for remote devices via a WAN link. Those two are most likely from Comcast, i.e. the gateway.. 


The last three are dynamic TCP ports, which I suspect are from Windows computers on your network. 


SInce they're on the LAN side, and not the WAN, they're internal to your network, and quite normal, so I wouldn't be worried about them. 

Comcast Experts are other customers who volunteer their time helping on the forum and have been recognized by the community. For more information on the Expert Program, please click here.
Unless so specifically stated, my opinions written herein are my own and do not necessarily reflect the views of Comcast, its official employees or affiliates.