Xfinity plant
Community Forum
Xfinity globe

Pair XR 11 Voice Remote to a Denon Receiver AVR 1609

New Poster

Pair XR 11 Voice Remote to a Denon Receiver AVR 1609

i am trying (unsuccessfully) to pair my XR 11 Comcast remote to a Denon AVR 1609. I can't seem get it going . Have tried every code I have found

 

Please help

 

Scotty

Expert

Re: Pair XR 11 Voice Remote to a Denon Receiver AVR 1609

Does your prompts show the option to pair an a/v receiver?

 

I have my TV connected to my receiver by HDMI and my X1 stb is also connected to my receiver by HDMI.  Is that your setup?

 

Official Employee

Re: Pair XR 11 Voice Remote to a Denon Receiver AVR 1609

Hello jayzee714. Please confirm you are following these steps below and that you have tried all of the below remote codes for Denon:

 

Program your remote using the RF pairing:

  1. Install the remote control batteries and make sure your TV and set-top box are powered on.
  2. Press and hold the "Setup" button until the LED at the top of the remote changes from red to green.
  3. Press the XFINITY button
  4. Enter the 3 digit code shown on your screen

Program your remote using a code:

  1. Turn on the Audio/Other you are programming.
  2. Press and hold the "Setup" button until the status LED at the top of the remote changes from red to green.
  3. Type in the 4-digit or 5-digit code listed below using the number buttons. Additional codes may be found in the remote manual.

    Most likely code

    31360

    Others to try

    32857, 33347, 32516, 31104, 32247, 32279, 32706, 32502, 31961, 32134, 34025, 31142, 31289, 31972

  4. If the code is entered correctly, the status LED will flash green twice. If the status LED blinks red, then green the code was not entered correctly. Check that you are entering the correct code and try again.
  5. Use the remote to operate your Audio/Other (use Power, VOL, etc.)
  6. If these steps don’t work, try another 4-digit or 5-digit code and repeat the above.