Community Forum

new tv all I get is no signal

Xfinity Forum Archive
About the archive project

Xfinity Forum Archive...

This is an archived section of the community.

Content in this area has been identified as outdated or irrelevant.

This change was done in an effort to make the forum easier to use and to keep only the most helpful and recent content active.

Post your questions in the Xfinity Community

New Poster

new tv all I get is no signal

I replaced a tv in my kitchen with a Sylvania TV/DVD/CD/Radio.  After following the instructions for setup I get no signal message when trying to plan the TV.  The DVD works fine.

Contributor

Re: new tv all I get is no signal

Try going into the Menu and find "Scan for channels" or something like that. Push the Select button or some button like that that will allow the TV to scan for channels. Once it completes the scan, you should be able to watch TV normally. Be sure and make certain that either a turned on cable box or an antenna is connected to the Input of the TV.

Official Employee

Re: new tv all I get is no signal

Either your tv is not on the right input or your tv isn’t on channel 3. Use your tv remote
I am an Official Comcast Employee.
Official Employees are from multiple teams within Comcast: Product, Support, Leadership. We ask that you post publicly so people with similar questions may benefit from the conversation.

Was your question answered? Mark the post as best answer!