Community Forum

interface to MX-990 Remote Control

Xfinity Forum Archive
About the archive project

Xfinity Forum Archive...

This is an archived section of the community.

Content in this area has been identified as outdated or irrelevant.

This change was done in an effort to make the forum easier to use and to keep only the most helpful and recent content active.

Post your questions in the Xfinity Community

New Poster

interface to MX-990 Remote Control

Do I need to use an IR emitter to connect the XG2v2-P to a Universal MX-990 remote control?  The controller is supposed to work with both RF and IR control.  I do not see a place on the front panel of the XG2 to stick the emitter on.  Thanks

Official Employee

Re: interface to MX-990 Remote Control


wrote:

Do I need to use an IR emitter to connect the XG2v2-P to a Universal MX-990 remote control?  The controller is supposed to work with both RF and IR control.  I do not see a place on the front panel of the XG2 to stick the emitter on.  Thanks


This thread has the IR locations

https://forums.xfinity.com/t5/X1/X1-Boxes-and-IR-Locations/m-p/2720333#M101085

New Poster

Re: interface to MX-990 Remote Control

Thanks for all the information—it was a great help and I was able to find the location on the Pace box to mount the IR emitter. The only additional requirement I had to do was reboot each of the four sources for the Universal Remote control to work—I am a happy camper!