Community Forum

Pair Yahama RX-V661 to Xfinity Remote to Power On, Off and Use Volume/Channels

Xfinity Forum Archive
About the archive project

Xfinity Forum Archive...

This is an archived section of the community.

Content in this area has been identified as outdated or irrelevant.

This change was done in an effort to make the forum easier to use and to keep only the most helpful and recent content active.

Post your questions in the Xfinity Community

New Poster

Pair Yahama RX-V661 to Xfinity Remote to Power On, Off and Use Volume/Channels

I have a Yamaha RX-V661 audio receiver I'm trying to pair with an Xfinity Remote.  I followed the instructions and tried to pair with all Yamaha codes that were provided.  The best I can do is to pair with Power Off and Volume, but have not been able to pair with the Power On of my Yamaha device.  Any ideas?  Thanks

Gold Problem Solver

Re: Pair Yahama RX-V661 to Xfinity Remote to Power On, Off and Use Volume/Channels

There are a few Yamaha and Harman Kardon receivers out there where this problem was never solved. I used to have an RX-V872 and it was never solved.

If you have tried every Yamaha code listed on the remote support site you may be out of luck.