Community Forum

Pair XR 11 Voice Remote to a Denon Receiver AVR 1609

Xfinity Forum Archive
About the archive project

Xfinity Forum Archive...

This is an archived section of the community.

Content in this area has been identified as outdated or irrelevant.

This change was done in an effort to make the forum easier to use and to keep only the most helpful and recent content active.

Post your questions in the Xfinity Community

New Poster

Pair XR 11 Voice Remote to a Denon Receiver AVR 1609

i am trying (unsuccessfully) to pair my XR 11 Comcast remote to a Denon AVR 1609. I can't seem get it going . Have tried every code I have found

 

Please help

 

Scotty

Silver Problem Solver

Re: Pair XR 11 Voice Remote to a Denon Receiver AVR 1609

Does your prompts show the option to pair an a/v receiver?

 

I have my TV connected to my receiver by HDMI and my X1 stb is also connected to my receiver by HDMI.  Is that your setup?

 

I am not a Comcast Employee.
I am just a customer, volunteering my time to help other customers here in the Forums.
Was your question answered? Mark the post as best answer!
Official Employee

Re: Pair XR 11 Voice Remote to a Denon Receiver AVR 1609

Hello jayzee714. Please confirm you are following these steps below and that you have tried all of the below remote codes for Denon:

 

Program your remote using the RF pairing:

  1. Install the remote control batteries and make sure your TV and set-top box are powered on.
  2. Press and hold the "Setup" button until the LED at the top of the remote changes from red to green.
  3. Press the XFINITY button
  4. Enter the 3 digit code shown on your screen

Program your remote using a code:

  1. Turn on the Audio/Other you are programming.
  2. Press and hold the "Setup" button until the status LED at the top of the remote changes from red to green.
  3. Type in the 4-digit or 5-digit code listed below using the number buttons. Additional codes may be found in the remote manual.

    Most likely code

    31360

    Others to try

    32857, 33347, 32516, 31104, 32247, 32279, 32706, 32502, 31961, 32134, 34025, 31142, 31289, 31972

  4. If the code is entered correctly, the status LED will flash green twice. If the status LED blinks red, then green the code was not entered correctly. Check that you are entering the correct code and try again.
  5. Use the remote to operate your Audio/Other (use Power, VOL, etc.)
  6. If these steps don’t work, try another 4-digit or 5-digit code and repeat the above.

I am an Official Comcast Employee.
Official Employees are from multiple teams within Comcast: CARE, Product, Leadership. We ask that you post publicly so people with similar questions may benefit from the conversation.
Was your question answered? Mark the post as Best Answer!