Community Forum

No dial tone, signal on TV & blinking lights on router/modem

Xfinity Forum Archive
About the archive project

Xfinity Forum Archive...

This is an archived section of the community.

Content in this area has been identified as outdated or irrelevant.

This change was done in an effort to make the forum easier to use and to keep only the most helpful and recent content active.

Post your questions in the Xfinity Community

New Poster

Re: No dial tone, signal on TV & blinking lights on router/modem

I never regained dial-tones on all the phone jacks.  The only one that worked was the jack were I had the DSL filter in my office.  The phone would work if I connected it to the filter.  Today, my service was interrupted approximately 10:40am.  I reset the modem, but the US/DS light just keeps blinking.  When I check on-line, everything is okay on ComCast end, but, my equipment says "unavailable".  Out of curiousity, do you have any clues as to what the issue may be?  There is a techician coming out tomorrow.

Administrator

Re: No dial tone, signal on TV & blinking lights on router/modem

Hi, just wanted to follow up. Have your issues been resolved at this time? -FC 

New Poster

No dial tone, signal on TV & blinking lights on router/modem

The outage end estimates on-line keep changing, what is going on ???