Community Forum

Manufacturer Code

New Poster

Manufacturer Code

Hello all:

 

Trying to find manufacturer codes as directed xfinity directions enclosed with Aim Anywhere Start manual/instructions, but apparently this is not recognized as a help topic.  Does anyone know three-digit code for Dynex flat screen? Any help is very much appreciated. Thank you all.

 

David "Digger" Graves

 

Gold Problem Solver

Re: Manufacturer Code


DiggerGraves wrote:

Hello all:

 

Trying to find manufacturer codes as directed xfinity directions enclosed with Aim Anywhere Start manual/instructions, but apparently this is not recognized as a help topic.  Does anyone know three-digit code for Dynex flat screen? Any help is very much appreciated. Thank you all.

 

David "Digger" Graves

 


3- digit codes are for normally used for PAIRING a remote to the DVR/Xi3 in the X1 system...  5 digit codes are used for remote control of TV's.....

 

-=Ray=-

Official Employee

Re: Manufacturer Code


DiggerGraves wrote:

Hello all:

 

Trying to find manufacturer codes as directed xfinity directions enclosed with Aim Anywhere Start manual/instructions, but apparently this is not recognized as a help topic.  Does anyone know three-digit code for Dynex flat screen? Any help is very much appreciated. Thank you all.

 

David "Digger" Graves

 


This site may assist.  https://customer.xfinity.com/remotes/

 

For the XR2 remote and the Dynex TV, the below may be what you need:

 

1. Turn on the TV you are programming.
2. Press and hold the "Setup" button on your remote until the status LED changes from red to green.
3. Type in the 4-digit or 5-digit code listed below using the number buttons. Additional codes may be found in the remote manual.

 

Most likely code 11463
Others to try 11780, 11785


4. If the code is entered correctly, the status LED will blink green twice. If the status LED blinks red, then green the code was not entered correctly. Check that you are entering the correct code and try again.
5. Use the remote to operate your TV (use Power, VOL, etc.)
6. If these steps don’t work, try another 4-digit or 5-digit code and repeat the above.

New Poster

Re: Manufacturer Code

Unless you are setting up a very old remote in which case the led flashes red and not green.
Expert

Re: Manufacturer Code


@Nensea wrote:
Unless you are setting up a very old remote in which case the led flashes red and not green.

You are replying to a 3-year-old thread.  I am closing it.