Community Forum

xFi Questions: Dual Band and Pods

Xfinity Forum Archive
About the archive project

Xfinity Forum Archive...

This is an archived section of the community.

Content in this area has been identified as outdated or irrelevant.

This change was done in an effort to make the forum easier to use and to keep only the most helpful and recent content active.

Post your questions in the Xfinity Community

Official Employee

Re: xFi Questions: Dual Band and Pods


@schacht_w wrote:
So, do I need to physically change the two unique SSID names and associated passwords to one common SSID, and password name?

Are the xFi Pods compatible with the firmware level of my Gateway?

You don't have to if you don't want to, you'll be prompted to combine them at time of install through the Xfi app. I'm not sure what the latest firmware is, you won't know for sure until time of install

Frequent Visitor

Re: xFi Questions: Dual Band and Pods

So, do I need to physically change the two unique SSID names and associated passwords to one common SSID, and password name?

Are the xFi Pods compatible with the firmware level of my Gateway?
Official Employee

Re: xFi Questions: Dual Band and Pods


@schacht_w wrote:
Just upgraded to an Arris dual band Gateway.
Firmware: TG1682_2.8p15s1_PROD_sey Rev. 12.0
I’ve set it up with 2 distinct network names and passwords (for better or worse).

Questions:
1. Is this best practice?
Or should I go back and change them both to same SSID and password. If so, should do the bands need to be defined on separate channels?

2. I’m thinking of get xFi Pods.
Are they compatible with the above Gateway firmware level?

3. I’ve read where getting the Pods installed properly will not work with unique band network names? Is this correct?
If so, can I assume that question 1 needs to be addressed?

Any advice is appreciated.
Thanks,
Wayne

When the Xfi Pods are installed your gateway automatically will turn into one combined network

Frequent Visitor

xFi Questions: Dual Band and Pods

Just upgraded to an Arris dual band Gateway.
Firmware: TG1682_2.8p15s1_PROD_sey Rev. 12.0
I’ve set it up with 2 distinct network names and passwords (for better or worse).

Questions:
1. Is this best practice?
Or should I go back and change them both to same SSID and password. If so, should do the bands need to be defined on separate channels?

2. I’m thinking of get xFi Pods.
Are they compatible with the above Gateway firmware level?

3. I’ve read where getting the Pods installed properly will not work with unique band network names? Is this correct?
If so, can I assume that question 1 needs to be addressed?

Any advice is appreciated.
Thanks,
Wayne