Xfinity Forum Archive...
This is an archived section of the community.
Content in this area has been identified as outdated or irrelevant.
This change was done in an effort to make the forum easier to use and to keep only the most helpful and recent content active.
Post your questions in the Xfinity Community
That amount is small but it depends on the total uptime of the modem.
The stats as read at the modem level at that moment in time were o/k but there are three additional signal stats that can cause problems which can't be read by the modem. They can only be read from their end by them polling the CMTS (Cable Modem Termination System) at the local headend facility.
They are the "Upstream Rx Power" (Upstream Receive Power Level), the "Upstream SNR Ch." (Upstream Signal To Noise Ratio), and the "Upstream ICFR" (In Channel Frequency Response). These are as equally important in diagnosing connectivity issues as are the modem's stats.
You can call in and ask what these figures are. The Upstream Receive Power Level should fall within the range of -2dB to +2dB with 0dB being in the middle and perfect.
The Upstream SNR should be least 31dB, and the higher it is the better.
The ICFR should be no higher than 2 dB.
You could have an intermittent noise ingress issue in only the upstream channel(s) / return path only somewhere.
They will be able to see whether or not everything is in the green zone and also see a history plot for the modem.