Xfinity plant
Community Forum
Xfinity globe

Gap between peices of Door Sensor?

Xfinity Forum Archive
About the archive project

Xfinity Forum Archive...

This is an archived section of the community.

Content in this area has been identified as outdated or irrelevant.

This change was done in an effort to make the forum easier to use and to keep only the most helpful and recent content active.

Post your questions in the Xfinity Community

Highlighted
New Poster

Gap between peices of Door Sensor?

I was curiuos if anyone has installed a door sensor a sliding glass door where the stationary part and the part that slide don't line up (i.e. the sliding part of the door is recessed about 1/2 inch from the stationary part it slides into). I have a door sensor that I'd like to put there but am concerned with the gap causing issues with the sensor thinking the door is open.

 

Thanks


Accepted Solutions
Official Employee

Re: Gap between peices of Door Sensor?

Hello dgrizzanti, the magnet in the sensors are powerful enough for that kind of gap. However, the post from 

test1234x is correct as well. I ended up doing the same thing for my door/window sensor and this is what I used. 


All Replies
Official Employee

Re: Gap between peices of Door Sensor?

My kitchen sliding glass door has that type of situation... and I have not had an issue. I suppose if you needed to, you could add and extra piece or two of double sticky 3M tape to the back of the sensor to bump it out far enough to make the right connection, but I didn't have to do that in my case.
Official Employee

Re: Gap between peices of Door Sensor?

Hello dgrizzanti, the magnet in the sensors are powerful enough for that kind of gap. However, the post from 

test1234x is correct as well. I ended up doing the same thing for my door/window sensor and this is what I used.