Welcome to Xfinity Help & Support Forums
Find solutions, share knowledge, and get answers from customers and experts

New to the Community? Start here.








Programming Remote

New Poster

Programming Remote

I have a recently acquired Insignia television and and a standard Xfinity remote.

I am attempting to program the remote.

I have completed the channel scan (as suggested by the Insignia "help" folks) . The screen tells me that I have found only three channels (3,33, and 69). When I go through the programming protocall using code 10463, all the lights flash appropriately. The Xfinity remote will then allow me to adjust the volume, control the "mute" function and turn off the television just once. It will not let me change channels or turn the set on. I must use the Insignia remote to regain power.

What am I doing wrong?

Xfinity Forum Archive
About the archive project

Xfinity Forum Archive...

This is an archived section of the community.

Content in this area has been identified as outdated or irrelevant.

This change was done in an effort to make the forum easier to use and to keep only the most helpful and recent content active.

Post your questions in the Xfinity Community

Discussion stats
  • 0 replies
  • 0 kudos
  • 1 in conversation